I am trialing Polyscript and rather like it.

However, when i use the read and write file commands the result output is all on one line.

It there a trick to getting the output to be the same as the terminal session it came from, ie with the new line characters.

Ian

Dear Ian,

The new line character must be sent from the device you're connected to.

Some devices (such as unix - xterm) are not sending this character because they are sending a location of where to move the caret, instead of sending the new line character.

It's a known problem, and we will do our best to solve this issue on the next release.

Kind regards,

Marian Soriu